openwrt

OpenWRT firmware for routers

You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

Go to file

Felix Fietkau 9621d872ca (3/6) bcm57xx: preinit This patch allows the bcm57xx module to work correctly with failsafe mode. insmod doesn't return an error when a module loads but doesn't detect a switch. I added the check_module function to load the module, then make sure it doesn't just exit immediately. This allows preinit to only attempt to load the bcm57xx module when switch-robo and switch-adm dont detect a switch. The activate_gpio parameter to bcm57xx simply instructs the module to attempt to activate the switch via gpio before probing for the switch. Tested on wrt350n. Signed-off-by: Ben Pfountz <netprince (at) vt (dot) edu> SVN-Revision: 11468		16 years ago
docs	fix a small dep bug in the docs/ dir	16 years ago
include	remove accidentally committed swap file	16 years ago
package	(1/6) bcm57xx: init from diag	16 years ago
scripts	use the european kernel.org mirror too	16 years ago
target	(3/6) bcm57xx: preinit	16 years ago
toolchain	finally fixes etrax toolchain problems, thanks nbd	16 years ago
tools	Added lua (lua host bytecode-compiler) to tools/	16 years ago
.gitignore	update svn:ignore and .gitignore	16 years ago
BSDmakefile	add missing copyright header	18 years ago
Config.in	adds missing patch for native toolchain	16 years ago
LICENSE	finally move buildroot-ng to trunk	8 years ago
Makefile	large improvement for parallel builds. works without V=99 now and without warnings. tested with -j on an 2x dual core opteron machine	16 years ago
README	add information about the tex4ht requirement for the docs	18 years ago
feeds.conf	Switched xwrt url in feeds.conf (berlios http falls over occasionally)	17 years ago
rules.mk	adds missing patch for native toolchain	16 years ago

README

This is the buildsystem for the OpenWrt Linux distribution

Please use "make menuconfig" to configure your appreciated
configuration for the toolchain and firmware.

You need to have installed gcc, binutils, patch, bzip2, flex, bison,
make, gettext, pkg-config, unzip, libz-dev and libc headers.

Simply running 'make' will build your firmware.
It will download all sources, build the cross-compile toolchain, 
the kernel and all choosen applications.

You can use scripts/flash.sh for remotely updating your embedded system
via tftp.

The OpenWrt system is documented in docs/. You will need a LaTeX distribution
and the tex4ht package to build the documentation. Type make -C docs/ to build it.

Building your own firmware you need to have access to a Linux, BSD or MacOSX system.
Cygwin will not be supported because of the lack of case sensitiveness.

Sunshine!
	Your OpenWrt Project
	http://openwrt.org