You cannot select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
1ffb7e47be
* Backport much of the 10.2 firmware features from upstream QCA driver.
This includes ANI support, adaptive CCA, tx-hang workarounds,
and lots of other things.
Not all of this may be enabled at this point, and more code waits to
be backported as time and motivation allows.
* Fix some rate-control issues where ath10k in station mode (at least), would
sometimes get stuck at low rates. This appeared to be a probe related
state machine issue in the firmware, so I added some timeout logic to kick
the state machine if it gets stuck. This signicantly improves throughput
tests with many stations.
* Support configuring WMI WD timeout using SET_SPECIAL API.
* Properly configure the rx-mask on bootup to work around problem found
by Mr. Kazior. This should remove the need to add the driver hack he
posted.
* Allow configuring pdev failed-retry threshold. This is how many consecutive
tx failures the firmware will allow before resetting the wifi chip (not a full
firmware crash).
Signed-off-by: Ben Greear <greearb@candelatech.com>
|
8 years ago | |
|---|---|---|
| .. | ||
| am33x-cm3 | 8 years ago | |
| ath10k-firmware | 8 years ago | |
| b43legacy-firmware | 9 years ago | |
| ixp4xx-microcode | 8 years ago | |
| lantiq/dsl-vrx200-firmware-xdsl | 8 years ago | |
| linux-firmware | 8 years ago | |
| prism54-firmware | 8 years ago | |
| vsc73x5-ucode | 8 years ago | |