You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
openwrt/target/linux
Roman Hampel cd510e775b ath79: add support for Comfast CF-WR752AC v1
Specifications:

- Qualcomm QCA9531 + QCA9886
- dual band, antenna 2*3dBi
- Output power 50mW (17dBm)
- 1x 10/100 Mbps LAN RJ45
- 128 MB RAM / 16 MB FLASH (w25q128)
- 3 LEDs (red/green/blue)
  incorporated in
  "color wheel reset switch"
- UART 115200 8N1

Flashing instructions:

 The U-boot bootloader contains a recovery HTTP server
 to upload the  firmware. Push the reset button while powering the
 device on and keep it pressed for ~10 seconds. The device's LEDs will
 blink several times and the recovery page will be at
 http://192.168.1.1; use it to upload the sysupgrade image.

 Alternatively, the original firmware is based on OpenWrt so a
 sysupgrade image can be installed via the stock web GUI. Settings from
 the original firmware will be saved and restored on the new one, so a
 factory reset will be needed. To do so, once the new firmware is flashed,
 enter into failsafe mode by pressing the reset button several times during
 the boot process, until it starts flashing. Once in failsafe mode, perform
 a factory reset as usual.

LED-Info:

 The LEDs on the Comfast stock fw have a very proprietary behaviour,
 corresponding to the user selected working mode (AP, ROUTER or REPEATER).
 In the first two cases, only blue is used for status and LAN signaling. When
 using the latter, blue is always off (except for sysupgrade), either red
 signals bad rssi on master-link, or green good. Since the default working
 mode of OpenWrt resembles that of a router/AP, the default behavior is
 implemented accordingly.

MAC addresses (art partition):

location  address (example)    use in vendor firmware
0x0       xx:xx:xx:xx:xc:f8 -> eth0
0x6       xx:xx:xx:xx:xc:fa -> wlan5g (+2)
0x1002    xx:xx:xx:xx:xc:f9 -> not used
0x5006    xx:xx:xx:xx:xc:fb -> not used
---       xx:xx:xx:xx:xd:02 -> wlan2g (+10)

The same strange situation has already been observed and documented
for COMFAST CF-E560AC.

Signed-off-by: Roman Hampel <rhamp@arcor.de>
Co-developed-by: Joao Albuquerque <joaohccalbu@gmail.com>
Signed-off-by: Joao Albuquerque <joaohccalbu@gmail.com>
[adjust and extend commit message, rebase, minor DTS adjustments,
add correct MAC address for wmac, change RSSI LED names and behavior]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
4 years ago
..
apm821xx treewide: Don't diverge from upstream default HZ settings on 4.19 4 years ago
ar71xx ar71xx: Fix gigabit switch support for Mikrotik RB951G-2HnD 4 years ago
arc770 treewide: remove maintainer variable from targets 4 years ago
archs38 archs38: switch to kernel 5.4 by default 4 years ago
armvirt kernel: move TEO governor to generic config 4 years ago
at91 treewide: remove maintainer variable from targets 4 years ago
ath25 treewide: remove maintainer variable from targets 4 years ago
ath79 ath79: add support for Comfast CF-WR752AC v1 4 years ago
bcm27xx kernel: bump 5.4 to 5.4.31 4 years ago
bcm47xx treewide: remove maintainer variable from targets 4 years ago
bcm53xx bcm53xx: add support for Luxul FullMAC WiFi devices 4 years ago
bcm63xx treewide: gather DEVICE_VARS into one place 4 years ago
cns3xxx treewide: remove maintainer variable from targets 4 years ago
gemini gemini: Refine package list 4 years ago
generic kernel: bump 5.4 to 5.4.31 4 years ago
imx6 imx6: bootscript: use partition UUID for rootfs if possible 4 years ago
ipq40xx ipq40xx: fix DAP-2610 boot failure 4 years ago
ipq806x ipq806x: switch to 5.4 kernel 4 years ago
ipq807x treewide: remove maintainer variable from targets 4 years ago
kirkwood kirkwood: fix DTS partitions for Pogoplug E02 4 years ago
lantiq kernel: bump 5.4 to 5.4.28 4 years ago
layerscape treewide: remove maintainer variable from targets 4 years ago
malta malta: Remove kernel 4.14 support 4 years ago
mediatek kernel: bump 5.4 to 5.4.31 4 years ago
mpc85xx treewide: Don't diverge from upstream default HZ settings on 4.19 4 years ago
mvebu mvebu: cortexa9: correct cpu subtype 4 years ago
mxs kernel: bump 5.4 to 5.4.28 4 years ago
octeon treewide: remove maintainer variable from targets 4 years ago
octeontx octeontx: switch to kernel 5.4 4 years ago
omap treewide: gather DEVICE_VARS into one place 4 years ago
oxnas kernel: bump 5.4 to 5.4.31 4 years ago
pistachio treewide: remove maintainer variable from targets 4 years ago
ramips ramips: use full 8MB flash on ZyXEL Keenetic 4 years ago
rb532 treewide: remove maintainer variable from targets 4 years ago
samsung treewide: remove maintainer variable from targets 4 years ago
sunxi kernel: bump 5.4 to 5.4.28 4 years ago
tegra tegra: correct cpu subtype 4 years ago
uml treewide: Remove self from MAINTAINER entries 4 years ago
x86 x86/64: add cdrom and iso9660 drivers 4 years ago
zynq zynq: switch to kernel 5.4 4 years ago
Makefile