openwrt

You cannot select more than 25 topics Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.

History

Hauke Mehrtens ca7f9638d5 broadcom-diag: support for the WNDR3700v3 I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the bootloader and stock firmware will accept. The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving its LEDs through an HC164 8-bit shift register. Signed-off-by: Owen Kirby <osk@exegin.com> SVN-Revision: 36482	11 years ago
..
src	broadcom-diag: support for the WNDR3700v3	11 years ago
Makefile	broadcom-diag: SimpleShare: expose power button as reset to the system, remove actual reset button - it's hardwired and will reset the SoC (#7928 )	14 years ago

Hauke Mehrtens ca7f9638d5 broadcom-diag: support for the WNDR3700v3

I recently picked up a WNDR3700 to put OpenWRT on, and only after tearing into the box did I find it
was one of the v3 boards, with poor OpenWRT support. This patch should add the board detection and
LED/button control to the broadcom-diag module, and should generate a netgear .chk image that the
bootloader and stock firmware will accept.

The changes to the broadcom-diag module are more than a few lines because the WNDR3700v3 is driving
its LEDs through an HC164 8-bit shift register.

Signed-off-by: Owen Kirby <osk@exegin.com>

SVN-Revision: 36482

src

broadcom-diag: support for the WNDR3700v3

Makefile

broadcom-diag: SimpleShare: expose power button as reset to the system, remove actual reset button - it's hardwired and will reset the SoC (#7928 )