From patchwork Fri Feb 7 09:53:35 2020 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Daniel Golle X-Patchwork-Id: 1190470 Date: Fri, 7 Feb 2020 11:53:35 +0200 From: Daniel Golle To: linux-serial@vger.kernel.org, linux-kernel@vger.kernel.org Cc: Greg Kroah-Hartman , Jiri Slaby , Chuanhong Guo , Eitan Cohen , Ori Gofen Subject: [PATCH] serial: ar933x_uart: set UART_CS_{RX,TX}_READY_ORIDE Message-ID: <20200207095335.GA179836@makrotopia.org> MIME-Version: 1.0 Content-Disposition: inline Sender: linux-kernel-owner@vger.kernel.org Precedence: bulk List-ID: X-Mailing-List: linux-kernel@vger.kernel.org On AR934x this UART is usually not initialized by the bootloader as it is only used as a secondary serial port while the primary UART is a newly introduced NS16550-compatible. In order to make use of the ar933x-uart on AR934x without RTS/CTS hardware flow control, one needs to set the UART_CS_{RX,TX}_READY_ORIDE bits as other than on AR933x where this UART is used as primary/console, the bootloader on AR934x typically doesn't set those bits. Setting them explicitely on AR933x should not do any harm, so just set them unconditionally. Tested-by: Chuanhong Guo Signed-off-by: Daniel Golle --- drivers/tty/serial/ar933x_uart.c | 8 ++++++++ 1 file changed, 8 insertions(+) --- a/drivers/tty/serial/ar933x_uart.c +++ b/drivers/tty/serial/ar933x_uart.c @@ -286,6 +286,10 @@ static void ar933x_uart_set_termios(stru ar933x_uart_rmw_set(up, AR933X_UART_CS_REG, AR933X_UART_CS_HOST_INT_EN); + /* enable RX and TX ready overide */ + ar933x_uart_rmw_set(up, AR933X_UART_CS_REG, + AR933X_UART_CS_TX_READY_ORIDE | AR933X_UART_CS_RX_READY_ORIDE); + /* reenable the UART */ ar933x_uart_rmw(up, AR933X_UART_CS_REG, AR933X_UART_CS_IF_MODE_M << AR933X_UART_CS_IF_MODE_S, @@ -418,6 +422,10 @@ static int ar933x_uart_startup(struct ua ar933x_uart_rmw_set(up, AR933X_UART_CS_REG, AR933X_UART_CS_HOST_INT_EN); + /* enable RX and TX ready overide */ + ar933x_uart_rmw_set(up, AR933X_UART_CS_REG, + AR933X_UART_CS_TX_READY_ORIDE | AR933X_UART_CS_RX_READY_ORIDE); + /* Enable RX interrupts */ up->ier = AR933X_UART_INT_RX_VALID; ar933x_uart_write(up, AR933X_UART_INT_EN_REG, up->ier);