Commit Graph

2 Commits (5b3afca7576887be509eb21950009851676a1acb)

Author SHA1 Message Date
Kevin Darbyshire-Bryant 5b3afca757 kernel: bump 4.14 to 4.14.90
Refresh all patches

Remove upstream patch:
backport-4.14/424-v4.20-net-dsa-fix-88e6060-roaming.patch

Minor tweak to generic/hack-4.14/902-debloat_proc.patch to cleanly apply
after upstream changes.

Tested-on: ath79

Signed-off-by: Kevin Darbyshire-Bryant <ldir@darbyshire-bryant.me.uk>
5 years ago
Koen Vandeputte 6835c13e5a cns3xxx: fix writing to wrong PCI registers
Originally, cns3xxx used it's own functions for mapping, reading and writing registers.

Upstream commit 802b7c06adc7 ("ARM: cns3xxx: Convert PCI to use generic config accessors")
removed the internal PCI config write function in favor of the generic one:

cns3xxx_pci_write_config() --> pci_generic_config_write()

cns3xxx_pci_write_config() expected aligned addresses, being produced by cns3xxx_pci_map_bus()
while the generic one pci_generic_config_write() actually expects the real address
as both the function and hardware are capable of byte-aligned writes.

This currently leads to pci_generic_config_write() writing
to the wrong registers on some ocasions.

First issue seen due to this:

- driver ath9k gets loaded
- The driver wants to write value 0xA8 to register PCI_LATENCY_TIMER, located at 0x0D
- cns3xxx_pci_map_bus() aligns the address to 0x0C
- pci_generic_config_write() effectively writes 0xA8 into register 0x0C (CACHE_LINE_SIZE)

This seems to cause some slight instability when certain PCI devices are used.

Another issue example caused by this this is the PCI bus numbering,
where the primary bus is higher than the secondary, which is impossible.

Before:

00:00.0 PCI bridge: Cavium, Inc. Device 3400 (rev 01) (prog-if 00 [Normal decode])
    Flags: bus master, fast devsel, latency 0, IRQ 255
    Bus: primary=02, secondary=01, subordinate=ff, sec-latency=0

After fix:

00:00.0 PCI bridge: Cavium, Inc. Device 3400 (rev 01) (prog-if 00 [Normal decode])
    Flags: bus master, fast devsel, latency 0, IRQ 255
    Bus: primary=00, secondary=01, subordinate=02, sec-latency=0

And very likely some more ..

Fix all by omitting the alignment being done in the mapping function.

Signed-off-by: Koen Vandeputte <koen.vandeputte@ncentric.com>
5 years ago