Browse Source

ramips: correct WizFi630S pin mappings

WizFi630S had some pins changed in the release version of the board.
The run led, wps button and a slide switch where affected.
This patch is correcting this.
i2c is removed as it is sharing a pin with the run (system) led.
uart2 is enabled as it is also enabled in the OEM firmware.

Signed-off-by: Tobias Welz <tw@wiznet.eu>
master
Tobias Welz 2 years ago
committed by Adrian Schmutzler
parent
commit
d0b229f553
  1. 34
      target/linux/ramips/dts/mt7628an_wiznet_wizfi630s.dts

34
target/linux/ramips/dts/mt7628an_wiznet_wizfi630s.dts

@ -28,7 +28,7 @@
led_run: run {
label = "wizfi630s:green:run";
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
};
ledwps {
@ -61,47 +61,29 @@
wps {
label = "wps";
gpios = <&gpio 32 GPIO_ACTIVE_HIGH>;
gpios = <&gpio 41 GPIO_ACTIVE_LOW>;
linux,code = <KEY_WPS_BUTTON>;
};
scm1 {
label = "SCM1";
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
linux,code = <BTN_1>;
linux,input-type = <EV_SW>;
};
scm2 {
label = "SCM2";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
linux,code = <BTN_2>;
linux,input-type = <EV_SW>;
};
};
};
&state_default {
gpio {
groups = "gpio";
function = "gpio";
};
i2s {
groups = "i2s";
function = "gpio";
};
wdt {
groups = "wdt";
function = "gpio";
};
i2c {
groups = "i2c";
function = "gpio";
};
refclk {
groups = "refclk";
groups = "gpio", "i2s", "i2c", "wdt", "refclk", "p1led_an", "p2led_an";
function = "gpio";
};
};
@ -150,11 +132,11 @@
};
};
&i2c {
&uart1 {
status = "okay";
};
&uart1 {
&uart2 {
status = "okay";
};

Loading…
Cancel
Save