ath79: add support for Compex WPJ344

Specifications:

SoC: AR9344
DRAM: 128MB DDR2
Flash: 16MB SPI-NOR
2 Gigabit ethernet ports
2×2 2.4GHz on-board radio
miniPCIe slot that supports 5GHz radio
PoE 48V IEEE 802.3af/at - 24V passive optional
USB 2.0 header

Installation:

To install, either start tftp in bin/targets/ath79/generic/ and use
the u-boot prompt over UART:

tftpboot 0x80500000 openwrt-ath79-generic-compex_wpj344-16m-squashfs-sysupgrade.bin
erase 0x9f030000 +$filesize
erase 0x9f680000 +1
cp.b $fileaddr 0x9f030000 $filesize
boot

The cpximg file can be used with sysupgrade in the stock firmware (add
SSH key in luci for root access) or with the built-in cpximg loader.
The cpximg loader can be started either by holding the reset button
during power up or by entering the u-boot prompt and entering 'cpximg'.
Once it's running, a TFTP-server under 192.168.1.1 will accept the image
appropriate for the board revision that is etched on the board.

For example, if the board is labelled '6A08':

tftp -v -m binary 192.168.1.1 -c put openwrt-ath79-generic-compex_wpj344-16m-squashfs-cpximg-6a08.bin

MAC addresses:

<&uboot 0x2e010>  *:99  (label)
<&uboot 0x2e018>  *:9a
<&uboot 0x2e020>  *:9b
<&uboot 0x2e028>  *:9c

Only the first two are used (for ethernet), the WiFi modules have
separate (valid) addresses. The latter two addresses are not used.

Signed-off-by: Leon M. George <leon@georgemail.eu>
[minor commit message adjustments, drop gpio in DTS, DTS style fixes,
sorting, drop unused cpximg recipe]
Signed-off-by: Adrian Schmutzler <freifunk@adrianschmutzler.de>
master
Leon M. George 5 years ago committed by Adrian Schmutzler
parent f09b9319c6
commit a0bb356612

@ -0,0 +1,153 @@
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "ar9344.dtsi"
/ {
compatible = "compex,wpj344-16m", "qca,ar9344";
model = "Compex WPJ344 (16MB flash)";
aliases {
label-mac-device = &eth0;
led-boot = &led_status;
led-failsafe = &led_status;
led-running = &led_status;
led-upgrade = &led_status;
};
leds {
compatible = "gpio-leds";
led_status: status {
label = "wpj344:green:status";
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
};
sig1 {
label = "wpj344:red:sig1";
gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
};
sig2 {
label = "wpj344:yellow:sig2";
gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
};
sig3 {
label = "wpj344:green:sig3";
gpios = <&gpio 21 GPIO_ACTIVE_LOW>;
};
sig4 {
label = "wpj344:green:sig4";
gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
};
};
keys {
compatible = "gpio-keys";
reset {
linux,code = <KEY_RESTART>;
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
};
&ref {
clock-frequency = <40000000>;
};
&uart {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
uboot: partition@0 {
label = "u-boot";
reg = <0x000000 0x030000>;
read-only;
};
partition@30000 {
label = "firmware";
reg = <0x030000 0xfc0000>;
compatible = "denx,uimage";
};
art: partition@ff0000 {
label = "art";
reg = <0xff0000 0x010000>;
read-only;
};
};
};
};
&usb {
status = "okay";
};
&usb_phy {
status = "okay";
};
&pcie {
status = "okay";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
};
&mdio0 {
status = "okay";
phy-mask = <0>;
phy0: ethernet-phy@0 {
reg = <0>;
phy-mode = "rgmii";
qca,ar8327-initvals = <
0x04 0x07600000 /* PORT0 PAD MODE CTRL */
0x10 0x80000080 /* POWER_ON_STRIP */
0x50 0x00000000 /* LED_CTRL0 */
0x54 0xc737c737 /* LED_CTRL1 */
0x58 0x00000000 /* LED_CTRL2 */
0x5c 0x00c30c00 /* LED_CTRL3 */
0x7c 0x0000007e /* PORT0_STATUS */
>;
};
};
&eth0 {
status = "okay";
pll-data = <0x06000000 0x00000101 0x00001616>;
mtd-mac-address = <&uboot 0x2e010>;
phy-mode = "rgmii";
phy-handle = <&phy0>;
};

@ -115,6 +115,13 @@ engenius,ecb1750|\
enterasys,ws-ap3705i)
ucidef_set_led_netdev "lan" "LAN" "$boardname:blue:lan" "eth0"
;;
compex,wpj344-16m)
ucidef_set_rssimon "wlan0" "200000" "1"
ucidef_set_led_rssi "sig1" "SIG1" "wpj344:red:sig1" "wlan0" "85" "100"
ucidef_set_led_rssi "sig2" "SIG2" "wpj344:yellow:sig2" "wlan0" "75" "100"
ucidef_set_led_rssi "sig3" "SIG3" "wpj344:green:sig3" "wlan0" "65" "100"
ucidef_set_led_rssi "sig4" "SIG4" "wpj344:green:sig4" "wlan0" "50" "100"
;;
compex,wpj531-16m)
ucidef_set_rssimon "wlan0" "200000" "1"
ucidef_set_led_rssi "sig1" "SIG1" "wpj531:red:sig1" "wlan0" "85" "100"

@ -131,6 +131,10 @@ ath79_setup_interfaces()
ucidef_add_switch "switch0" \
"0@eth0" "1:lan" "2:lan" "3:lan" "4:lan" "5:wan" "6@eth1"
;;
compex,wpj344-16m)
ucidef_add_switch "switch0" \
"0@eth0" "3:lan" "2:wan"
;;
devolo,dvl1200e|\
devolo,dvl1750e|\
ocedo,ursus)
@ -366,6 +370,9 @@ ath79_setup_macs()
lan_mac=$(fritz_tffs -n maca -i $(find_mtd_part "tffs (1)"))
wan_mac=$(fritz_tffs -n macb -i $(find_mtd_part "tffs (1)"))
;;
compex,wpj344-16m)
wan_mac=$(mtd_get_mac_binary u-boot 0x2e018)
;;
devolo,magic-2-wifi)
label_mac=$(macaddr_add "$(mtd_get_mac_binary art 0x1002)" 3)
;;

@ -441,6 +441,19 @@ define Device/comfast_cf-wr752ac-v1
endef
TARGET_DEVICES += comfast_cf-wr752ac-v1
define Device/compex_wpj344-16m
SOC := ar9344
DEVICE_PACKAGES := kmod-usb2
IMAGE_SIZE := 16128k
DEVICE_VENDOR := Compex
DEVICE_MODEL := WPJ344
DEVICE_VARIANT := 16M
SUPPORTED_DEVICES += wpj344
IMAGES += cpximg-6a08.bin
IMAGE/cpximg-6a08.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | pad-rootfs | mkmylofw_16m 0x690 3
endef
TARGET_DEVICES += compex_wpj344-16m
define Device/compex_wpj531-16m
SOC := qca9531
DEVICE_PACKAGES := kmod-usb2

Loading…
Cancel
Save