ath79: add support for Compex WPJ563

Specifications:

SoC: QCA9563
DRAM: 128MB DDR2
Flash: 16MB SPI-NOR
2 Gigabit ethernet ports
3×3 2.4GHz on-board radio
miniPCIe slot that supports 5GHz radio
PoE 24V passive or 36V-56V passive with optional IEEE 802.3af/at
USB 3.0 header

Installation:

To install, either start tftp in bin/targets/ath79/generic/ and use
the u-boot prompt over UART:

tftpboot 0x80500000 openwrt-ath79-generic-compex_wpj563-squashfs-sysupgrade.bin
erase 0x9f680000 +1
erase 0x9f030000 +$filesize
cp.b $fileaddr 0x9f030000 $filesize
boot

The cpximg file can be used with sysupgrade in the stock firmware (add
SSH key in luci for root access) or with the built-in cpximg loader.
The cpximg loader can be started either by holding the reset button
during power up or by entering the u-boot prompt and entering 'cpximg'.
Once it's running, a TFTP-server under 192.168.1.1 will accept the image
appropriate for the board revision that is etched on the board.

For example, if the board is labelled '7A02':

tftp -v -m binary 192.168.1.1 -c put openwrt-ath79-generic-compex_wpj563-squashfs-cpximg-7a02.bin

MAC addresses:

<&uboot 0x2e010>  *:71  (label)
<&uboot 0x2e018>  *:72
<&uboot 0x2e020>  *:73
<&uboot 0x2e028>  *:74

Only the first two are used (for ethernet), the WiFi modules have
separate (valid) addresses. The latter two addresses are not used.

Signed-off-by: Leon M. George <leon@georgemail.eu>
master
Leon M. George 5 years ago committed by Adrian Schmutzler
parent f8ea7c53fd
commit 15f585afc5

@ -0,0 +1,145 @@
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;
#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>
#include "qca956x.dtsi"
/ {
model = "Compex WPJ563";
compatible = "compex,wpj563", "qca,qca9563";
aliases {
label-mac-device = &eth0;
led-boot = &led_sig4;
led-failsafe = &led_sig4;
led-running = &led_sig4;
led-upgrade = &led_sig4;
};
beeper {
compatible = "gpio-beeper";
gpios = <&gpio 19 GPIO_ACTIVE_HIGH>;
};
keys {
compatible = "gpio-keys";
reset {
label = "reset";
linux,code = <KEY_RESTART>;
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
debounce-interval = <60>;
};
};
leds {
compatible = "gpio-leds";
sig1 {
label = "wpj563:green:sig1";
gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
};
sig2 {
label = "wpj563:green:sig2";
gpios = <&gpio 5 GPIO_ACTIVE_LOW>;
};
sig3 {
label = "wpj563:green:sig4";
gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
};
led_sig4: sig4 {
label = "wpj563:green:sig4";
gpios = <&gpio 7 GPIO_ACTIVE_LOW>;
};
};
};
&pcie {
status = "okay";
};
&spi {
status = "okay";
num-cs = <1>;
flash@0 {
compatible = "jedec,spi-nor";
reg = <0>;
spi-max-frequency = <25000000>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
uboot: partition@0 {
label = "u-boot";
reg = <0x000000 0x030000>;
read-only;
};
partition@30000 {
compatible = "denx,uimage";
label = "firmware";
reg = <0x030000 0xfc0000>;
};
art: partition@ff0000 {
label = "art";
reg = <0xff0000 0x010000>;
read-only;
};
};
};
};
&mdio0 {
status = "okay";
phy-mask = <0>;
phy0: ethernet-phy@0 {
reg = <0>;
phy-mode = "sgmii";
qca,mib-poll-interval = <500>;
qca,ar8327-initvals = <
0x04 0x00080080 /* PORT0 PAD MODE CTRL */
0x7c 0x0000007e /* PORT0_STATUS */
>;
};
};
&eth0 {
status = "okay";
pll-data = <0x03000101 0x00000101 0x00001919>;
mtd-mac-address = <&uboot 0x2e010>;
phy-mode = "sgmii";
phy-handle = <&phy0>;
};
&usb_phy0 {
status = "okay";
};
&usb0 {
status = "okay";
};
&uart {
status = "okay";
};
&wmac {
status = "okay";
mtd-cal-data = <&art 0x1000>;
};

@ -135,7 +135,8 @@ ath79_setup_interfaces()
ucidef_add_switch "switch0" \
"0@eth0" "1:lan" "2:lan" "3:lan" "4:lan" "5:wan" "6@eth1"
;;
compex,wpj344-16m)
compex,wpj344-16m|\
compex,wpj563)
ucidef_add_switch "switch0" \
"0@eth0" "3:lan" "2:wan"
;;
@ -383,7 +384,8 @@ ath79_setup_macs()
lan_mac=$(fritz_tffs -n maca -i $(find_mtd_part "tffs (1)"))
wan_mac=$(fritz_tffs -n macb -i $(find_mtd_part "tffs (1)"))
;;
compex,wpj344-16m)
compex,wpj344-16m|\
compex,wpj563)
wan_mac=$(mtd_get_mac_binary u-boot 0x2e018)
;;
devolo,magic-2-wifi)

@ -502,6 +502,18 @@ define Device/compex_wpj531-16m
endef
TARGET_DEVICES += compex_wpj531-16m
define Device/compex_wpj563
SOC := qca9563
DEVICE_PACKAGES := kmod-usb2 kmod-usb3
IMAGE_SIZE := 16128k
DEVICE_VENDOR := Compex
DEVICE_MODEL := WPJ563
SUPPORTED_DEVICES += wpj563
IMAGES += cpximg-7a02.bin
IMAGE/cpximg-7a02.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | pad-rootfs | mkmylofw_16m 0x694 2
endef
TARGET_DEVICES += compex_wpj563
define Device/devolo_dvl1200e
SOC := qca9558
DEVICE_VENDOR := devolo

Loading…
Cancel
Save